Mitsubishi MOTORS OUTLANDER PHEV 2021, Owner'S Manual

Page: 350 / 403

How to change a tyre
For emergencies 9-15
9
2. Place the jack under one of the jacking
points (A) shown in the illustration. Use
the jacking point closest to the tyre you
wish to change.
3. Rotate the jack by hand until the flange
portion (B) fits in the groove (C) at the top
of the jack.
4. Check that the flange portion at the jack-
ing point fits in the groove at the top of
the jack.
Insert the jack bar (D) into the wheel nut
wrench (E). Then put the end of the jack
bar into the shaft’s jack end, as shown in
the illustration.
Slowly rotate the wheel nut wrench until
the tyre is raised slightly off the ground
surface.
WARNING
 Set the jack only at the positions shown
here. If the jack is set at a wrong position,
it could dent your vehicle or the jack
might fall over and cause personal injury.
 Do not use the jack on a tilted or soft sur-
face.
Otherwise, the jack might slip and cause
personal injury. Always use the jack on a
flat, hard surface. Before setting the jack,
make sure there are no sand or pebbles
under the jack base.
WARNING
 Stop jacking up the vehicle as soon as the
tyre is raised off the ground. It is danger-
ous to raise the vehicle any higher.
 Do not get under your vehicle while using
the jack.
 Do not bump the raised vehicle or leave it
sitting on the jack for a long time. Both
are very dangerous.
 Do not use a jack except the one that came
with your vehicle.