Mitsubishi MOTORS OUTLANDER PHEV 2021, Owner'S Manual

Page: 123 / 403

Seat belt inspection
5-22 Seat and seat belts
5
E00408702174
1. Put a child restraint system on the seat in
which you wish to install it, and remove
the head restraint from the seat.
Refer to “Head restraints” on page 5-4.
2. Route the belt through the child restraint
according to the child restraint system
manufacturer’s instructions, then insert
the latch plate into the buckle.
3. Remove all slack of a lap belt by pulling
the webbing through the belt’s adjustment
feature.
3-point type seat belt requires no length
adjustment, remove all slack by using the
locking clip.
4. If your child restraint system has a sup-
port leg, make sure that there is a support
leg at the stable position on the floor.
5. Before putting the child in the restraint,
push and pull the restraint in all directions
to be sure it is secure. Do this before each
use.
E00406301690
Check the belts for cuts, worn or frayed web-
bing and for cracked or deformed metallic
parts. Replace the belt assembly if defective.
Installing a child restraint sys-
tem to a 3-point type seat belt
(with emergency locking mech-
anism)
Installation:
CAUTION
 Do not remove the head restraint when
installing a booster cushion.
WARNING

For some types of child restraint, the lock-
ing clip (A) should be used to help avoid
personal injury during a collision or sud-
den manoeuvre.
It must be fitted and used in accordance
with the child restraint manufacturer’s
instructions.
The locking clip must be removed when
the child restraint is removed.
Seat belt inspection
WARNING
 We recommend you to have all seat belt
assemblies including retractors and
attaching hardware inspected after any
collision. We recommend that seat belt
assemblies in use during a collision be
replaced unless the collision was minor
and the belts show no damage and con-
tinue to operate properly.