Mitsubishi MOTORS OUTLANDER PHEV 2021, Owner'S Manual

Page: 254 / 403

Cruise control*
Starting and driving 7-51
7
The set speed driving is deactivated automati-
cally in any of the following ways.
 When your speed slows to approximately
15 km/h or more below the set speed
because of a hill, etc.
 When your speed slows to approximately
40 km/h or less.
 When the active stability control (ASC)
starts operating.
Refer to “Active stability control (ASC)”
on page 7-45.
E00609802187
If the set speed driving is deactivated by the
condition described in “To deactivate” on
page 7-50, you can resume the previously set
speed by push up the “RES +” switch (C)
while driving at a speed of approximately 40
km/h or higher.
The “SET” indicator appears on the informa-
tion screen in the meter cluster.
Under either of the following conditions,
however, using the switch does not allow you
to resume the previously set speed. In these
situations, repeat the speed setting procedure:

The CRUISE CONTROL ON/OFF
switch is pressed.
 The operation mode is put in OFF.
 Indicator display goes off.
WARNING
 Although the set speed driving will be
deactivated when shifting to the “N”
(NEUTRAL) position, never move the
selector lever to the “N” (NEUTRAL)
position while driving.
You would have no regenerative brake
and could cause a serious accident.
CAUTION
 When the set speed driving is deactivated
automatically in any situation other than
those listed above, there may be a system
malfunction.
Press the CRUISE CONTROL ON/OFF
switch to turn off the cruise control and have
your vehicle inspected by a MITSUBISHI
MOTORS Authorised Service Point.
NOTE
 You cannot operate the regenerative brake
while the adaptive cruise control system
(ACC) is operating.
 If you perform the following operations, a
buzzer may sound and the select position
may automatically shift to “N” position.
• The electrical parking switch is pressed
during driving.
• The selector lever is shifted to “R” during
driving forward.
• The selector lever is shifted to “D” during
driving backward.
• The selector lever is shifted to “B” when
the select position is in “R”.
To resume the set speed