Mitsubishi MOTORS OUTLANDER PHEV 2021, Owner'S Manual

Page: 183 / 403

Indicator lamps
6-50 Instruments and controls
6
E00501600100
E00501701717
These indicator lamps blink in
the following situations.
 When the turn-signal lever
is moved to activate a turn-
signal lamp.
Refer to “Turn-signal lever” on page 6-62.
 When the hazard warning flasher switch
is pressed to activate the hazard warning
lamps.
Refer to “Hazard warning flasher switch”
on page 6-63.
E00501800173
E00501901650
E00508900173
E00530101061
The ready indicator keeps
flashing until Plug-in Hybrid
EV System is activated. When
the Plug-in Hybrid EV System
has activated normally and the
vehicle becomes ready to run, the lamp stops
flashing and stays lit. Refer to “Starting the
Plug-in Hybrid EV System” on page 7-15.
If the indicator keeps flashing, the vehicle
cannot drive.
E00530201062
This indicator flashes when
the EV charging cable or
quick charging cable is con-
nected.
After that, the lamp switches
to being illuminated when charging starts and
goes out when charging is completed.
E00502400147
E00502504234
This lamp illuminates when
the operation mode of the
power switch is put in ON,
and goes off after a few sec-
onds.
Always make sure that the lamp goes off
before driving.
Indicator lamps
Turn-signal indicator
lamps/Hazard warning indica-
tor lamps
High-beam indicator lamp
This indicator lamp illumi-
nates when the high beam is
used.
Front fog lamp indicator lamp
This lamp illuminates while
the front fog lamps are on.
Position lamp indicator lamp
This indicator lamp illumi-
nates while the position lamps
are on.
Ready indicator
Charging indicator
NOTE
 Although it is possible to start the Plug-in
Hybrid EV System if quick charging has not
finished normally, the charging indicator is
continuously blinking.
Refer to “Charging troubleshooting guide”
on page 3-27.
Warning lamps
Brake warning lamp