Mitsubishi MOTORS OUTLANDER PHEV 2021, Owner'S Manual

Page: 328 / 403

220-240 V AC power supplies
For pleasant driving 8-21
8
CAUTION
 When the 220-240 V AC power supply is not
in use, be sure to cancel power supply by
pressing the 220-240 V AC power supply
switch, disconnect the plug and close the lid.
This will prevent the 220-240 V AC power
supply from becoming clogged and short cir-
cuiting.

Do not stand behind the exhaust pipe as the
engine may automatically start depending on
the condition. Heat from the exhaust could
lead to burns.
 Make sure that the plug is inserted all the
way into the 220-240 V AC power supply
before using an electrical appliance.

Do not use an electrical appliance in the
vehicle which emits heat such as a heater.
Heat damage to interior parts could result.
 Do not connect a malfunctioning electrical
appliance to the 220-240 V AC power sup-
ply. Doing so could damage the 220-240 V
AC power supply.
NOTE
 If the plug of the electrical appliance was
loose or wobbled when inserted in the outlet,
replace the 220-240 V AC power supply by a
MITSUBISHI MOTORS Authorised Service
Point.
 Never leave the vehicle, perform refueling or
washing the vehicle while using the
220-240 V AC power supply.
 You may hear operating sounds such as
sounds from the cooling fan near luggage
area when using the 220-240 V AC power
supply. This is not a malfunction.

Never use electrical appliance which is vul-
nerable to vibration or heat in the cabin.
When exposed to the strong direct sunlight,
the cabin will become extremely hot. It could
cause product failure.
 Do not use the 220-240 V AC power supply
with the vehicle covered by a car cover.

When closing the window, door or tailgate,
be careful not to trap the power supply cord.
 220-240 V AC power supply cannot be used
in the following cases.
• When Plug-in Hybrid EV System warning
lamp is illuminated.
• When the drive battery level display indi-
cates 0.
• When the “PROPULSION POWER IS
REDUCED” warning display appears.
 Electrical appliance may not operate nor-
mally or electricity supply stops under the
following conditions. You may hear an oper-
ation noise. This is normal.
• When the power consumption of the electri-
cal appliance exceeds 1500 W.
• When the vehicle interior temperature is
too hot or too cold.

When the 220-240 V AC power supply can-
not be used or is not returned to operation
automatically after stopping electricity sup-
ply, follow the procedures below.
NOTE
1. Disconnect the plug of electrical appli-
ance.
2. Confirm the remaining quantity of the
drive battery. When it is low, charge the
drive battery by using the battery
SAVE/CHARGE mode switch, etc.
Refer to “SAVE/CHARGE mode switch”
on page 7-31.
Refer to “Normal charging (charging
method with rated AC 220 V outlet)” on
page 3-10.
Refer to “Quick charging (charging
method with quick charger)” on page
3-16.
3. Confirm the ready indicator illuminates.
If not, start the Plug-in Hybrid EV Sys-
tem.
4. When the vehicle interior temperature is
too hot or too cold, adjust it appropriately
by using air conditioner.
5. Press the 220-240 V AC power supply
switch to turn on.
6. Confirm the indicator lamp on 220-240 V
AC power supply switch comes on and
insert the plug in the power outlet.
If the 220-240 V AC power supply cannot be
used after performing the above steps, have
your vehicle checked by a MITSUBISHI
MOTORS Authorised Service Point.
NOTE