Minebea Intec CAW2P, Operating Instructions Manual

Page: 136 / 224

7.10.5.5 Weighing in Percent with Two Weighing Platforms
You can use two weighing platforms simultaneously with the Weighing in Percent
application. When using two platforms, you can choose from the following operating
modes:
- Weighing in percent with two platforms of the same type (see chapter 7.10.5.5.1 ).
- Weighing in percent with one reference platform and one weighing platform (see
chapter 7.10.5.5.2 ).
7.10.5.5.1 Weighing in Percent with Two Weighing Platforms
Use this mode to count diferent types of sample material with diferent weights. For
example, count the lighter-weight pieces on one platform and the heavier pieces on
another. You can deine one of the two scales as the reference scale.
The reference scale is the irst scale active when you switch on the device, regardless of
the setting for automatic initialization of the application.
7.10.5.5.2 Weighing in Percent with Two Weighing Platforms
In this operating mode, the reference platform is a high-resolution weighing platform
with a relatively low maximum capacity. The other platform is used for weighing heavier
samples, and has a high capacity with a relatively low resolution. This allows you to both
determine the reference sample weight with high resolution; i.e., very precisely, and to
count large amounts of parts, without requiring an expensive high-resolution, high-
capacity weighing platform.
The system can be conigured to switch automatically to the reference platform for
initialization (the measured value line shows [REF]). Following initialization, you can
switch to the counting platform.
Setting: [APPLIC.] - [APPLIC.1] - [PERCENT] - [REF.WP] (3.13) (see chapter
7.10.5 or 6.1.1.4 ).
7.10.6 Example: Weighing in Percent
100% of a sample material should be weighed.
Coniguration : The "Weighing in Percent" application is selected, and printout has been
set up (see chapter 7.16 ).
This is not required if the automatic tare function is active. The tare weight is saved
automatically when you place the container on the platform.
1. Place empty container on the scale.
2. Tare the scale with key.
Combics 2 Series Complete Scales Models CAW2P, CAW2S 7 Operating
EN-134 Minebea Intec