Section 4
Basic Operation
107
MikroScan 7600PRO
Operator’s Manual
Catalog 11180-94
V15.4F 050406
4.6.3 Manual Focusing
1) Verify the display is in
[Run]
mode and that no other parameter is
highlighted.
2) Turn the focusing ring on the camera clockwise or
counter-clockwise as needed until the image appears in focus.
[FOCuSInG RInG]
Turnng the focusng rng clockwse wll move the focal pont
toward the far focus
range of infinity. Turning the focusing ring
counter-clockwse wll brng the focal pont to the near focus
range of 50 cm.
4.7 Adjusting the Temperature Level
The center temperature of the scale s called the Temperature Level. The temperature
level settng determnes the span of temperature dsplayed on the screen wthn the
overall temperature
range. Ideally, the span should embrace most of the temperatures of
nterest and be equally dsplaced about some medan temperature n the target area.
To adjust the temperature level:
Toggle the
jOyStICK
up or down as needed to change the
temperature level
After Adjustment
[teMPeRAtuRe LeVeL]
[teMPeRAtuRe LeVeL]
before Adjustment
TIP
It may be helpful to
switch to a monochrome
display before focus-
ing. See Section 4.6.2
for more information
on Switching between a
Color an Monochrome
Display.
TIP
It may be helpful to
switch to a monochrome
display before focus-
ing. See Section 4.6.2
for more information
on Switching between a
Color an Monochrome
Display.
NOTE:
If the temperature of the
target area exceeds the
upper or lower limit of
the selected range, the
range setting will need to
be adjusted accordingly
(See Sections 4.3 and 4.4
of this manual for more
information on tempera-
ture ranges).
NOTE:
If the temperature of the
target area exceeds the
upper or lower limit of
the selected range, the
range setting will need to
be adjusted accordingly
(See Sections 4.3 and 4.4
of this manual for more
information on tempera-
ture ranges).
Summary of Contents for 7600PRO
Page 2: ......
