Mercedes-Benz C 240, Operator'S Manual

Page: 281 / 482

279
Controls in detail
Useful features
Operation of integrated remote control
왘
Switch on ignition (
컄
page 33).
왘
Select and press the appropriate
integrated signal transmitter button
(
2 , 3 or 4 ) to activate the remote
controlled device.
The integrated remote control trans-
mitter continues to send the signal as
long as the button is pressed – up to
20 seconds.
Erasing the integrated remote control
memory
왘
Switch on ignition (
컄
page 33).
왘
Simultaneously hold down the signal
transmitter buttons
2 and 4 , for
approximately 20 seconds, until the
indicator lamp
1 flashes rapidly. Do
not hold for longer than 30 seconds.
The codes of all three channels are
erased.
Reprogramming a single integrated
signal transmitter button
To program a device using a signal trans-
mitter button previously trained, follow
these steps:
왘
Press and hold the desired signal
transmitter button (
2 , 3 or 4 ).
Do not release the button.
왘
The indicator lamp will begin to flash
after 20 seconds. Without releasing
the integrated signal transmitter
button, proceed with programming
starting with step 3.
i
If you sell your vehicle, erase the codes
of all three channels.