MBO SVC 525C, Translation Of The Original Operating Manual, Page: 161 / 171

Sheeter SVC 525C 157
Maintenance
Maintenance
9.4.5 Changing the plastic ring
Here's how to proceed to change the plastic ring.
Prerequisites These prerequisites must be fulfilled:
• Main switch is switched off and secured.
• The electrotechnical regulations are heeded.
Changing the
plastic ring
Here's how to change the plastic ring:
1) Loosen the fastening screws (1).
2) Loosen the compressed air connections (5).
3) Loosen the PG union joint (2).
4) Remove the plastic ring (3) from the slitter shaft.
5) Push the new plastic ring on the slitter shaft.
6) Reattach the PG union joint (2).
7) Reconnect the compressed air connections (5).
8) Tighten the fastening screws (1).

The plastic ring is changed.
During removal and installation, make sure that you do not damage the
temperature sensor (4) or its cable.
1 Screw
2 PG union joint
3 Plastic ring
4 Temperature sensor
5 Compressed air connection
Illustration 79: Change the plastic ring
1
5
4
3
2