MBO SVC 525C, Translation Of The Original Operating Manual, Page: 100 / 171

96 Sheeter SVC 525C
Set-up, commissioning
Commissioning
7.4 Commissioning
• After the stationary mains connection, the machine must be commis-
sioned.
• Separate installation and commissioning instructions are required for
this.
7.5 Final check of the protective devices
After commissioning the machine, be absolutely certain to carry out a final
check of the protective devices.
Procedure:

Check that all covers and protective devices are installed and fully func-
tional.
For this purpose, use the checklist for the protective devices.
See chapter “4.5 Checkliste Sicherheits- und Schutzeinrichtungen”.
7.6 Inspection after initial operation
Proceed as follows to conduct the inspection after initial operation.
Prerequisites These prerequisites must be fulfilled:
• The machine is ready for operation.
Carrying out an in-
spection
Here's how to carry out an inspection:

Check all tapes and belts to make sure they run centered and have the
necessary tension.

If required, readjust these.
See Maintenance chapter.

The inspection has been carried out.
Only have the machine commissioned by MBO Service or by a customer
service technician authorized by MBO.
20 operating hours after initial operation, it is necessary to perform an
inspection of all belts and tapes.