MBO SVC 525C, Translation Of The Original Operating Manual, Page: 117 / 171

Sheeter SVC 525C 113
Adjustment and operation
Adjusting the machine
8.4.7 Adjusting the short belts after the cutting cylinder unit
Here's how to proceed to adjust the belts
Prerequisites These prerequisites must be fulfilled:
• The web is smoothed.
Adjusting the belts
Here's how to adjust the belts after the cutting cylinder unit:
1) On the shaft (2), push the belt (1) to the desired, next possible crowned
position.
2) Hold the left side in position with a finger.
3) Let the machine run until the belt is positioned over the desired position
(o-ring) of the right shaft.
4) Make adjustments for all belts.

The belts are adjusted.
1 Belt 2 Shaft
Illustration 56: Adjust the belts after the cutting cylinder unit.
1
2
Both outside belts must be as flush as possible with the web.
Distribute the middle belts evenly across the remaining width.