215104
38
Revision A
3.4
Installing Drive Wheels
NOTE:
If using the factory stand, proceed to Step
; otherwise, skip to Step
1005586
A
B
Figure 3.13: Lift Locks
1.
Ensure the three (one at rear, two at front) lift locks are
activated on the lift mechanism.
NOTE:
The lock is activated when keeper (A) is vertical and
latch (B) is free to move back and forth.
2.
Pressurize the air bag system (690 kPa [100 psi] air pressure
required) and raise the windrower to the maximum height
(approximately 178 mm [7 in.]) above the stand.
1005589
A
Figure 3.14: Lift Locks
3.
Verify that all three locks are engaged before proceeding to
the next step.
NOTE:
Lock is engaged when the witness hole (A) above the pin is
exposed.
4.
Release pressure until the locks support the weight of the
windrower.
1005590
A
B
Figure 3.15: Drive Wheel Shipping Support
5.
Remove shipping support (A) from the drive wheel hub, and
remove the wheel lug nuts (B).
