215104
112
Revision A
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.31: CDM Programming Buttons
1.
Turn the ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the cab display
module (CDM) to enter programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1011819
CXXX
EXXX
DWA INSTALLED?
NO/YES
B
A
Figure 4.32: DWA Controls
4.
Press SELECT (B) until DWA INSTALLED? is displayed on the
upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
1023730
CXXX
EXXX
SWAP DWA CONTROLS?
NO/YES
Figure 4.33: DWA Controls
6.
SWAP DWA CONTROLS? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
NOTE:
This step swaps the DWA controls from the console switch
to the ground speed lever (GSL) reel fore-aft buttons.