215104
215
Revision A
6.4.2
Attaching an R or R1 Series Rotary Disc Header
–
Hydraulic Center-Link without
Optional Self-Alignment
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1021748
A
B
C
Figure 6.79: Header Support
2.
Remove hairpin (B) from clevis pin (A), and then remove
clevis pin from header support (C) on both sides of the
header.
1029714
A
B
Figure 6.80: Header Float Linkage
IMPORTANT:
To prevent damage to the lift system when lowering header
lift linkages without a header or weight box attached to the
windrower, ensure the float engagement pin is installed in
storage position (B) and
NOT
in engaged position (A).
3.
To disengage float springs, move the float engagement pin
from engaged position (A) and insert pin into storage
hole (B). Secure float engagement pin with lynch pin.
Repeat for opposite linkage.
1008925
A
Figure 6.81: Ground Speed Lever
CAUTION
Check to be sure all bystanders have cleared the area.
IMPORTANT:
Before starting engine for the first time the windrower is
operated in a season, remove the protective cover from the
exhaust stack.
4.
Start the engine and activate HEADER DOWN button (A) on
the ground speed lever (GSL) to fully retract header lift
cylinders.
