215104
44
Revision A
3.6
Installing Hydraulics
1005648
A
A
A
Figure 3.26: Hydraulic Hoses
1.
Retrieve all capped hoses from inside the frame.
2.
Locate the three hoses with capped tees extending from
the valve block.
3.
Remove caps from the fittings with similar colored cable
ties, and connect hoses (A) to tees. Do
NOT
connect the
large case drain hoses from the wheel motors at this time.
NOTE:
Remove caps on tee last to minimize oil loss.
4.
Position hoses into frame.
5.
Locate the two hoses with capped ends and matching
colored ties. A union is connected to one of the hoses.
6.
Remove the caps and connect the two hoses together.
Position hoses in frame.
7.
Retrieve the four remaining capped hoses coming out of
the frame.
1029941
A
B
C
B
E
A
Figure 3.27: Hydraulic Valve and Hoses
8.
Loosen bolts (A) and move the valve block to improve
access through the hole in the frame in order to insert
wrenches and tighten fittings.
9.
Remove caps from hoses and matching valve block
fittings (B).
NOTE:
Some hoses are hidden for clarity.
10. Make connections using colored plastic cable ties as a
guide. Tighten fittings.
11. Reposition valve block and retighten bolts.