215104
117
Revision A
1022623
A
B
Figure 4.43: Swath Compressor Switch
9.
Press switch (B) on console to raise swath compressor.
•
CALIBRATING SWATH is displayed on upper line.
•
FORM UP and flashing HOLD is displayed on lower line
until system has completed reading signal with swath
compressor fully raised.
•
SWATH FORM UP and DONE (with buzzer) is displayed
on lower line when complete.
•
SWATH SENSOR CAL is displayed on upper line.
•
PRESS SWATH DOWN is displayed on lower line.
10. Press switch (A) on console to lower swath compressor.
•
CALIBRATING SWATH is displayed on upper line.
•
FORM DOWN and HOLD is displayed on lower line.
•
SWATH FORM COMPLETE flashes for 2 seconds on
lower line (with buzzer) when calibration is finished.
1011772
C###
E###
WINDROWER SETUP?
NO/YES
A
B
Figure 4.44: CDM Programming Buttons
11. Press PROGRAM (A) to exit programming mode or press
SELECT (B) to proceed to next windrower setup action.
