215104
132
Revision A
4.5
Displaying Activated Cab Display Lockouts
Displaying the activated control locks allows you to quickly determine which controls are locked on the cab display
module (CDM).
1011786
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.79: CDM Programming Buttons
1.
Turn the ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed on the upper line.
1011821
CXXX
EXXX
VIEW CONTROL LOCKS
NO/YES
B
A
Figure 4.80: Control Locks
4.
Press SELECT (B) until VIEW CONTROL LOCKS? is displayed
on the upper line.
•
NO/YES is displayed on the lower line.
5.
Press right arrow (A) to select YES. Press SELECT (B).
HEADER TILT is displayed on the upper line.
•
The control switch status is displayed on the lower line.
The hours displayed indicate when a switch was
enabled or locked.
1011822
CXXX
EXXX
DRAPER SPEED
575.1 HRS ENABLED
D
C
B
A
Figure 4.81: Control Locks
6.
Press left arrow (B) or right arrow (C) to cycle between
control switch lockouts. The displayed control switches are
as follows:
•
HEADER TILT
•
HEADER FLOAT
•
REEL FORE/AFT
•
DRAPER SPEED
•
AUGER SPEED
•
KNIFE SPEED
•
DISK SPEED
•
REEL SPEED
NOTE:
Not all control locks apply to every header.
