215104
75
Revision A
1005780
A
B
Figure 3.95: Radio Receptacle
6.
Position receptacle (A) (supplied with radio) into the
opening, and secure by bending tabs (B) on the receptacle
against the panel.
1005794
A
Figure 3.96: Radio Installed
7.
Insert the radio into the receptacle and attach the radio
bezel. Ensure the radio locks into position and faceplate (A)
is against the panel.
1006086
A
B
C
F
E
D
Figure 3.97: Six-Pin Connector Terminal Arrangement
A - Left Speaker Power (+)
B - Left Speaker Ground (
–
)
C - Radio Ground (
–
)
D - Right Speaker Ground (
–
)
E - Right Speaker Power (+)
F - Radio Power (+) (Live when Ignition is ON)
8.
Ensure the radio has a six-pin connector
(Packard #2977042) and a terminal arrangement as shown
at right. This enables the radio to connect to the
windrower
’
s six-pin radio connector wiring harness.
9.
Attach the following two additional wires from the wiring
harness to the radio:
a.
Circuit 503:
Red live-wire with 1/4 in. female blade
terminal provides power for the radio clock/memory if
radio is equipped with this feature.
b.
Circuit 315:
Black ground-wire attaches to the
radio body.
10. Plug the antenna cable into the radio.
