215104
184
Revision A
6.2
Attaching a D Series or D1 Series Draper Header
D and D1 Series Draper Headers can be attached to an M155
E4
Self-Propelled Windrower.
1008824
Figure 6.4: M155
E4
Draper Header Hydraulics
The M155
E4
Self-Propelled Windrower is factory-equipped to
run a D or D1 Series Draper Header.
If installing an HC10 Hay Conditioner, Reverser kit (MD #B4656)
is recommended. If necessary, obtain the recommended kit and
install it in accordance with the instructions supplied with
the kit.
Refer to the following instructions based on the type of center-
link installed on your windrower:
•
6.2.1 Attaching a D Series or D1 Series Draper Header
Hydraulic Center-Link with Optional Self-Alignment, page
184
•
6.2.2 Attaching a D Series or D1 Series Draper Header
Hydraulic Center-Link without Self-Alignment, page 190
6.2.1
Attaching a D Series or D1 Series Draper Header
–
Hydraulic Center-Link with
Optional Self-Alignment
NOTE:
Draper header boots must be installed onto the windrower lift linkage before starting this procedure. Refer to
Attaching Header Boots, page 183
WARNING
To avoid bodily injury or death from unexpected startup of the machine, always stop the engine and remove the key
from the ignition before leaving the operator
’
s seat for any reason.
1.
Shut down the engine, and remove the key from the ignition.
1000754
A
B
Figure 6.5: Header Leg
2.
Remove hairpin (A) from pins (B), and remove pins from
both header legs.
