215104
95
Revision A
3.20
Removing Windrower from Stand
The procedure for removing the windrower from the support stand differs depending on whether you are using a factory-
built stand or a field-constructed stand. Refer to the following procedures according to for your specific stand:
•
3.20.1 Removing Windrower from Factory Stand, page 95
•
3.20.2 Removing Windrower from Field Stand, page 95
3.20.1
Removing Windrower from Factory Stand
1005715
A
Figure 3.134: Air Control Valve Tripod
1.
Move valve handle (A) upwards to slightly raise the
windrower and take load off the lift locks.
1030089
A
A
A
Figure 3.135: Lift System
2.
Release three lift lock mechanisms (A) and turn the keeper
to keep the lock in the released position.
3.
Move the valve handle downwards to slowly release the
pressure from the air bag system and lower the windrower
to the ground.
CAUTION
Check to be sure all bystanders have cleared the area.
CAUTION
Ensure all three lifts have fully retracted and are clear of the
windrower frame before driving windrower ahead.
4.
Start the engine and drive the machine straight ahead,
leaving the shipping support channels supported on the
rear support stand.
3.20.2
Removing Windrower from Field Stand
1.
Position a jack under the jack point of each drive wheel leg and under the rear hitch.
2.
Raise jacks to take the weight off the stands, and remove stands.
3.
Lower windrower slowly to the ground, and remove jacks.
