215104
191
Revision A
1000757
A
B
Figure 6.21: Hydraulic Center-Link without Self-
Alignment Kit
4.
Remove pin (A) from frame linkage and raise center-link (B)
until hook is above the attachment pin on header. Replace
pin (A) to hold center-link in place.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
1000767
A
B
Figure 6.22: Header Leg and Boot
5.
Drive the windrower slowly forward until boots (A) enter
header legs (B). Continue driving slowly forward until the
lift linkages contact the support plates in the header legs
and the header nudges forward.
6.
Ensure the lift linkages are properly engaged in the header
legs and are contacting the support plates.
1022527
A
B
Figure 6.23: Ground Speed Lever
7.
Use the following GSL functions to position the center-link
hook above the header attachment pin:
•
HEADER TILT UP (A) to retract the center-link
•
HEADER TILT DOWN (B) to extend the center-link
8.
Shut down the engine, and remove the key from the
ignition.
