215104
106
Revision A
1011760
CXXX
EXXX
WINDROWER SETUP?
NO/YES
A
B
C
Figure 4.19: CDM Programming Buttons
1.
Turn the ignition key to RUN, or start the engine.
2.
Press PROGRAM (A) and SELECT (C) on the CDM to enter
programming mode.
•
WINDROWER SETUP? is displayed on the upper line.
•
NO/YES is displayed on the lower line.
3.
Press right arrow (B) to select YES. Press SELECT (C).
•
SET KNIFE SPEED? is displayed.
1011796
CXXX
EXXX
KNIFE OVERLOAD SPD?
-300 SPM
D
C
B
A
Figure 4.20: Knife Overload Speed
4.
Press SELECT (D) until KNIFE OVERLOAD SPD? is displayed
on the upper line.
•
Current overload speed is displayed on the lower line.
NOTE:
Default setting is -300 spm. Range is -500 to -100 spm.
5.
Press left (B) or right (C) arrows to set knife overload speed.
Press SELECT (D).
6.
Press PROGRAM (A) to exit programming mode or press
SELECT (D) to proceed to next WINDROWER SETUP action.
