215104
203
Revision A
1000757
A
B
Figure 6.52: Hydraulic Center-Link without Self-
Alignment Kit
4.
Remove pin (A) from frame linkage and raise center-link (B)
until hook is above the attachment pin on header. Replace
pin (A) to hold center-link in place.
IMPORTANT:
If the center-link is too low, it may contact the header as
the windrower approaches the header for hookup.
1000780
B
A
Figure 6.53: Header Support
5.
Drive the windrower slowly forward until windrower
feet (A) enter header supports (B). Continue driving slowly
forward until the feet engage the supports and the header
nudges forward.
1008948
A
B
Figure 6.54: Ground Speed Lever
6.
Use the following ground speed lever functions to position
the center-link hook above the header attachment pin:
•
HEADER TILT UP (A) to retract center-link
•
HEADER TILT DOWN (B) to extend center-link
7.
Stop engine and remove key from ignition.