Kval Edge-SS, Operation & Service Manual

Page: 75 / 180

About the Edge-SS Interface Screens
KVAL Operation/Service Manual
2-40
Edge-SS Main Screen
About the Edge-SS Main Control Section
Home Machine
This button starts the home sequence
on the machine, which scans to find a
physical reference point on the frame.
When this point is found, the position
is stored and then used to calculate
the location of all moves during the
machine process. The home sequence
must be performed every time the
machine is powered up or reset.
Reset Machine
If a fault occurs that cannot be cleared, press the
Reset Machine
button. This button will
reset the machine to the start position.
Important:
Press the
Home
button after resetting the machine
Setup Mode On/Off
Select
Setup Mode
to toggle on or off. In the
On
mode, a safe mode is active. The
machine will go through normal sequences except the cutting motors will be inactive.
Use this mode to check the machine operation without making a cut on the door. With
the setup mode set to on, the button will change to an orange background.
In the
Off
mode the machine is in normal operation.
Abort Job
Select to stop (abort) the process of the door that is currently running.
About Speed Control
Routine Speed Percent
Adjust the speed of the cut. Press but-
tons to use the graduated speeds or
select box and enter a desired speed.
The speed can be changed during real
time processing.