Kval Edge-SS, Operation & Service Manual

Page: 8 / 180

Table of Contents
KVAL Edge-SS Line System
About the Tool Path Preview Test Tab ..................................... 2-45
About the Tool Config Tabs ...................................................... 2-46
General Operating Controls ................................................................2-46
Unlock the Tool Slot Configuration ......................................................2-47
About the Tool Pop-up Screens ..........................................................2-47
About the Tool Pop-up Screens ..........................................................2-47
bout Tool Locations (Edge-SS) ...........................................................2-48
About Chisel Locations (Edge-SS) .....................................................2-49
About Using Tool Configuration ..........................................................2-50
Measuring Tool Length .......................................................................2-50
About Entering Data into the Pop-up Menu ........................................2-51
About the Status and Log Screens .......................................... 2-52
About the Status Screen ....................................................................2-52
About the Log Screen .........................................................................2-53
Definitions ................................................................................ 2-54
Chapter 3
Calibration of the Edge-SS Line
About Calibration ..................................................................... 3-2
About the Calibration Menus and the Calibration Reference Cut .........3-2
Before you Calibrate .............................................................................3-2
About the Calibration Tabs ....................................................... 3-3
Access to the Calibration Adjustments .................................................3-3
Unlock the Calibration (Option) .............................................................3-4
Enter a Positive or Negative Number? .................................................3-4
Axis Direction for the Edge-SS Front Section .......................................3-5
How to Enter Calibration Data ................................................. 3-6
About Restore Points ............................................................................3-6
About the Edge-SS Calibration Screen ................................... 3-7
Edge-SS Calibration Screen ................................................................3-7
Calibrating the Feelers ............................................................. 3-8
Identify the Hinge and Lock Head Designations ...................................3-9
Using the Carriage Axes Calibrations ...................................................3-9
About Tools Calibration .......................................................................3-10
Tool Slot Identification .........................................................................3-11
Chisel Locations .................................................................................3-12
Using the Tools Calibration ...................................................... 3-13
Typical Adjustments ............................................................................3-13