Kval Edge-SS, Operation & Service Manual

Page: 4 / 180

KVAL Endeavor System Operation Manual
KVAL Edge-SS Operation/Service Manual
NOTICE OF OWNERSHIP OF KVALCAM SOFTWARE AND LIMITED LICENSE TO
USE
READ THIS NOTICE CAREFULLY BEFORE USING THE KVALCAM SOFTWARE WHICH OPERATES
KVAL MACHINERY. THIS DOCUMENT CONSTITUTES NOTICE TO YOU THAT YOU HAVE A LIMITED
LICENSE TO USE THE KVALCAM SOFTWARE ON THE TERMS AND CONDITIONS APPEARING BELOW.
BY USING THE KVALCAM SOFTWARE YOU ARE CONSENTING TO BE BOUND BY THIS LIMITED
LICENSE. IF YOU DO NOT AGREE TO ALL OF THE TERMS OF THIS LICENSE, THEN DO NOT USE THE
KVALCAM SOFTWARE.
KVAL, Inc., is the owner of all rights in respect of the software and documentation (referred to as “Licensor”). You
are the purchaser of KVAL Machinery operated by the KVALCAM Software are the “Licensee”.
The computer program(s) and related documentation and materials (herein collectively referred to as “the KvalCAM
Software” and further defined herein) which are used in the operation of the KVAL Machinery are licensed, not sold,
to you for use only upon the limited terms of this license, and Licensor reserves any rights not expressly granted to
you. Licensor retains all ownership of the KvalCAM Software.
Title, ownership rights, and intellectual property rights in the KvalCAM Software shall remain with KVAL, Inc. The
KVALCAM Software is protected by copyright laws and treaties. Title and related rights in the content generated
through the KVALCAM Software are also the property of the Licensor and are protected by applicable law.
1. Definitions .
a.
“KVALCAM Software” means the KVALCAM computer application installed in the KVAL
Machinery and written documentation and materials provided to you, as well as any revisions or
updates of such computer application and documentation.
b.
“Install” means storing of the KVALCAM Software in the computer component of the KVAL
Machinery.
c.
“Use” means executing the KVALCAM Software for purpose of operating the KVAL
Machinery and use of the documentation for properly operating KVALCAM Software.
2. Grant of License .
a.
Licensor hereby grants Licensee a non-exclusive, non-transferable license to Use the KVAL-
CAM Software upon payment of all amounts due for the purchase of the related KVAL
Machinery.
b.
Licensee will make no copies of the KVALCAM Software or alter the KVALCAM Software
in any way. Title to the KVALCAM Software will remain vested in Licensor, and nothing in
this License will give or convey any right, title or interest therein to Licensee except as a
licensee.
c.
Licensee agrees that it will use the KVALCAM Software or related documentation directly or
indirectly for the benefit of Licensee, and only pursuant to the scope of the grant of the License
set forth herein.
d.
Licensee will not decode, alter, decompile, reverse engineer, perform reverse analysis on or
disassemble the KVALCAM Software.
e.
This License will terminate automatically if Licensee fails to comply with the limitations
described above.