Kontron FlexPAC, Manual

Page: 95 / 137

4. Determine the add-in card placement slot. Remove the single screw
securing the adjacent I /O slot cover (see Figures 5.6). Lift up and remove
the I /O slot cover from the expansion opening, saving the screw for later
use (see Figure5.7).
5. Guide the add-in card into the expansion slot. Using both hands, press it
down evenly into the socket (see Figure 5.8). Make sure the card is firmly
seated (see Figure 5.9).
6. Replace the single screw into the I /O bracket, to secure the add-in card
(see Figure 5.9).
7. If needed, use the extra supplied card retaining foam block to hold
multiple sized add-in cards in place. Peel off the tape to expose the
adhesive strip. Strategically attach it across the card retention plate,
parallel with the other stationary foam block.
NOTE: Do not position the self-adhesive foam block over the air vents
on the card retention plate (see Figure 5.10). Doing so, will
prevent proper airflow which may damage the FlexPAC.
8. Place the card retention plate back into the FlexPAC. First engage the
notched ends, on the left side, into their mating slots, then lower the right
end of the card retention plate, back into place. Make sure the foam block
is correctly aligned across the cards.
9. Using the phillips-head screwdriver, replace the two screws to secure the
right side of the card retention plate. Then replace the two upper screws
on the card retention plate (see Figure 5.3).
10. Place the unit face down on a flat, sturdy surface. The rear panel will be
facing upwards. Carefully slide the outer casing back onto the main
chassis.
11. Using the 3mm hex driver, replace the six rear panel screws. Do not over
tighten them.
5
■
Expanding the FlexPAC
5.5