Kontron FlexPAC, Manual

Page: 68 / 137

Initial Display First
This option allows the system to first initialize the AGP card on chip or the
display on the PCI slot.
NOTE: If the “On Board” option is selected, both the internal and external
display will be lost.
IDE HDD Block Mode
This option allows the hard disk controller to use the fast block mode to
transfer data to and from your hard disk drive.
Power On Function
This option determines the way you power “On” the system from the system
“Off” state.
On Board FDC Controller
Select “Enabled” if your system has a floppy disk controller (FDC) installed
on the system board and you wish to use it. If you install an add-in FDC or if
your system does not have a floppy disk drive, select “Disabled.” This option
allows you to select the on board FDD port.
On Board Serial/Parallel Port
These options allow you to select the on board serial and parallel ports and
their addresses.
Serial Port 1: 3F8/IRQ4
Serial Port 2: 2F8/IRQ3
Parallel Port: 378h/IRQ7
3
■
Configuration
3.20