Kontron FlexPAC, Manual

Page: 21 / 137

Removing the Keyboard
When transporting or not in use, the keyboard closes up neatly against the
flat-panel display. Not only is the screen protected, but the keyboard remains
with the main unit at all times. It can be easily released from the main unit
when ready for use.
1. Place the FlexPAC on a flat, sturdy surface with the carrying handle facing
up and the keyboard facing you.
2. Located on the top of the FlexPAC are two keyboard release buttons (see
Figure 1.5, Item 6). Press both buttons down simultaneously. This will
release the keyboard from the front of the unit.
3. Slightly lift up on the keyboard to remove the mounting tabs (see Figure
1.5, Item 10) out from the mounting slots (see Figure 1.4, Item 4). Place
the keyboard in front of the system. You can flip out the adjustment feet,
on the bottom of the keyboard, if you wish to modify the angle (see Figure
1.5, Item 9).
NOTE: The FlexPAC is shipped with the keyboard already connected,
however, the cable can be disconnected and re-connected when
needed. The keyboard cable connector is located on the lower
left side of the front panel, below the speaker (see Figure 1.4,
Item 2).
4. Closing Up the Keyboard - Before closing the keyboard up against the
flat-panel, insert the keyboard cable into the provided storage space
(channel) along the back of the keyboard (see Figure 1.6, Item 13). This
keeps the keyboard cable out of the way and protects it from becoming
pinched. Then, insert the mounting tabs (see Figure 1.5, Item 10) into their
mating slots (see Figure 1.4, Item 4) and close the keyboard up against the
flat-panel, making certain that the retaining hooks snap securely into place
(see Figure 1.5, Item 7).
1
■
Getting Started
1.8