Kontron FlexPAC, Manual

Page: 108 / 137

Troubleshooting the FlexPAC
In most cases, problems with personal computers are the result of improper
hardware or software configurations, such as conflicting add-in cards or
improper jumper settings. Improperly connected cables or loose connections
can also cause problems. A quick check of all your cable connections can
sometimes eliminate your problem.
When you troubleshoot your system, observe the way your equipment
behaves and collect all the pertinent data on the failure (error messages,
audible beeps, etc.) You then eliminate the causes of the problem, one by one.
This section focuses on some of the most common startup failures. If your
system experiences a failure not described in this section, call a representative
at Kontron’s technical support department for assistance.
Typical Startup Sequence
When you turn “On” your system, the FlexPAC executes a predefined set of
activities related to hardware initialization. This set of activities is known as
POST (Power-On Self Test). Your system must complete each step listed
below before you can consider the system operational.
1. Your system is properly connected into a grounded outlet and is receiving
power.
2. The system begins the POST. This test verifies that the system memory,
system board, floppy disk drive, hard disk drive and any other peripheral
devices are all operational.
3. As the POST test executes, it displays system values (processor type,
memory size, etc.) and settings on the screen. Be sure to verify that these
values match your actual system configurations.
NOTE: When a system experiences problems during startup, it either halts
the sequence, generates a written error message or issues a series of
beep codes to indicate that a failure has occurred.
6
■
Maintenance & Troubleshooting
6.7