Kontron FlexPAC, Manual

Page: 124 / 137

Mouse Fails to Work
If you have a mouse or other pointing device connected to the FlexPAC and it
fails to work, check the following items.
• Did you install the correct mouse driver on your hard drive?
• Is the cable for the mouse securely connected?
• Are the serial ports enabled? Are the serial port jumpers properly
configured?
• Are the serial ports on FlexPAC working properly? Connect another
peripheral device to the serial ports to find out.
• When using a PS/2 mouse, the BIOS will display the message “Mouse
Initialized” when it is properly connected. If this message did not appear
on the screen during POST, check the connection.
• There are four different types of mouse support for a PC-type computer
(Bus mouse, Serial mouse, USB mouse and a PS/2 mouse). Make sure the
BIOS and the operating system supports the type of mouse you are using.
• The FlexPAC touchpad is a PS/2 device. Only one PS/2 device may be
used at a time.
Battery Failure
If the error message “CMOS Battery Failed” appears during the POST test, it
indicates that the CMOS battery is no longer functional. Contact Kontron
technical support for assistance.
If the “Setup Configuration Utility” loses the system configuration
information when the FlexPAC is turned “Off,” the battery may be weak or
defective. Contact Kontron technical support for assistance.
NOTE: Danger of explosion if a new battery is incorrectly installed. Replace
the battery only with the same or equivalent type recommended by
the manufacturer. Discard used batteries according to the
manufacturer’s instructions.
6
■
Maintenance & Troubleshooting
6.23