Kontron FlexPAC, Manual

Page: 43 / 137

Installing Windows NT 4. 0 PCI Ethernet Drivers
Use the following procedure to install the PCI Ethernet drivers for Windows
NT 4.0. If you are not using Windows NT 4.0, not do not use this procedure.
1. Before you can install the PCI Ethernet drivers, you must first transfer the
Windows NT 4.0 drivers from the supplied “Drivers/User Manual” CD
onto a floppy diskette. This installation diskette will be used to load the
drivers.
2. Power “On” the FlexPAC. Insert the supplied “Drivers/User Manual” CD
into the CD-ROM and insert a formatted floppy diskette into the floppy
disk drive.
3. When the initial window comes up, click on LAN Card. Then click on
Intel Pro LAN Drivers.
4. In the “Create Install Disk” window, select the Windows NT 4.0 operating
system to begin the transfer. When the transfer is complete, remove both
the CD and the floppy diskette. Use the installation diskette you just
created to install the Ethernet/LAN drivers.
For Installation of Intel Pro/100 and also repeat process for installation
of Intel Pro/1000.
1. In the Windows NT 4.0 environment, click on the Start button.
2. Go to the Settings option and select Control Panel.
3. Double click on Network Adapters Add.
4. Select Have Disk... then insert the installation diskette you just created
into the floppy disk drive and click on Ok.
5. Click on Ok Close, then enter the IP address. Remove the floppy
diskette. Close all applications and restart the system for the changes to
take effect.
2
■
System Description
2.5