Kontron FlexPAC, Manual

Page: 32 / 137

Ethernet Connector
The FlexPAC 2GHz is equipped with a 10/100 Base-T ethernet network connector
and the FlexPAC 3GHz has an additional 10/100/1000 Base-T connector. The
RJ45 ethernet input jacks allows you to connect the FlexPAC into an existing
network. The ethernet ports are located in the expansion slot opening on the side
panel to the left of the display (see Figure 1.17).
External Monitor Port
The FlexPAC has an on board video controller, backed by 16MB of memory,
for driving the flat-panel display. The unit includes a 15-pin, high density,
sub-D VGA port for connecting an external monitor. I t is accessible on the
side panel, in the expansion slot opening (see Figure 1.9, Item 6). This analog
video monitor port supports either simultaneous (at the same resolution) or
independent display operation. It is not necessary to connect an external
monitor to the FlexPAC, but by using an external monitor you can achieve
higher resolutions than on the internal flat-panel display.
External Mouse
If preferred, a pointing device can be used in place of the embedded touchpad
on the standard keyboard included with the FlexPAC. Only a serial or USB
type mouse can be used along with the standard keyboard. If using a serial
mouse, use one of the 9-pin, RS-232 serial ports to connect it. If using a USB
mouse, use one of the USB ports to connect it. Please refer to the pointing
device-specific documentation for information on connecting and using the
external mouse. The serial and USB ports are located on the rear panel of the
FlexPAC (see Figure 1.8).
1
■
Getting Started
1.19