Kontron FlexPAC, Manual

Page: 111 / 137

General Hardware Problems
A few general problems and suggested solutions are presented below.
Problem Solution
The system will not power “On.” Check the power cable and make
certain it is connected to proper AC
power source.
The system does not display the Enter the “Setup Configuration Utility”
date and time correctly or at all. by pressing <Del> during the boot-up
sequence and correct the time and
date settings.
A: device is not recognized by the Open the “Setup Configuration Utility”
system. and enter the appropriate parameters for
the floppy disk drive.
The display screen is dark. • Make sure the system is powered “On.”
• Make sure the system is not in the
“Suspend” mode.
You hear irregular beep
sounds. Contact technical support.
You can’t read anything from the • Make sure the CD is properly placed in
CD-ROM.
the CD-ROM tray (label side up).
• Make sure you installed a CD into the
CD-ROM tray.
You can’t operate the printer. • Check the cable connection to the
printer.
• Make sure the printer is powered “On.”
• Confirm that the printer is “On-line.”
• Make sure the correct printer is selected
in “Setting Printers.”
You can’t save anything to a • The diskette is not formatted.
diskette. • The diskette is write protected or full.
• The disk drive is not working. Contact
Kontron technical support.
6
■
Maintenance & Troubleshooting
6.10