Ch.5 Printing from and Backup of External Devices
< 162 >
DRYPRO Vstage MODEL 793 Installation Manual Ver.1.00 2004.11
5.1 Printing from External Devices
The procedure for carrying out a check to ensure that print jobs sent from external devices can be
successfully printed is described below.
1
Connect one end of the Ethernet cable to the
Ethernet port (RJ45) at the back of DRYPRO
793.
- Connect the other end of the Ethernet cable to the
facility hub.
- A hub with auto-negotiation capabilities as a
110BASE-TX hub is recommended. The facility
network administrator should be consulted for
details.
- If using 100BASE-T, CAT5 or CAT6 LAN cable
should be used.
2
Send the queue from the external device and
check printing.
- If any problem arises, repeat the necessary
DRYPRO 793 setup procedures in accordance with
the section dealing with troubleshooting in the
service manual.
- If printing of the job sent from the external device
is successful, proceed to step-3.
3
Secure the Ethernet cable to the back of
DRYPRO 793 with two clamp accessories giving
due consideration to the place where the device
is installed.
