KEB COMBIVERT F5-A, Applications Manual, Page: 276 / 552

Page 7.11 - 10 COMBIVERT F5-A, -E, -H © KEB, 2012-10
Speed measurement
7.11.6
Encoder identifier
Before start-up the inverter must be adjusted to the used encoder.
Encoder interface 1 / 2 (Ec.00, Ec.10)
Ec.00 displays the installed encoder interface 1; Ec.10 displays theencoder interface 2. The values correspond
to following interfaces:
Ec.00, Ec.10: Encoder interface 1/ 2
Value Description
0 no
1 TTL-Incremental encoder input
2 Incremental encoder output 5 V TTL
3 Incremental encoder input and output direct
(non-divisible with Ec.27; switchable in- output with Ec.20)
4 Incremental encoder input and output TTL (switchable with Ec.20)
5 Initiator
6 Synchronous serial interface (SSI)
7 Resolver
8 Tacho
9 Incremental encoder output TTL (from resolver over channel 2)
10 Incremental encoder output TTL
11 Hiperface
12 Incremental encoder input 24 V HTL
13 Incremental encoder input TTL with error detection
14 SinCos encoder input
15 Incremental encoder input 24 V HTL with error detection (push-pull)
16 ENDAT
17 Incremental encoder input 24 V HTL with error detection
18 Analog option ±10 V
19 Reslover
20 SSI sincos
21 Overspeed limiter
22 UVW-Interface
23 Inc. emulation 10-30V
24 Inc. emulation 10-30V
25 Overspeed limiter HTL
26 Incremental encoder input TTL with error detection 5V supply terminal
27 Incremental encoder input HTL-push-pull terminal block with error detection
28 Endat/BiSS (switchable with Ec.62)
29 Incremental encoder output TTL variable
30 Position via Ec.28
In case of an invalid encoder identification, error „E.Hyb“ is indicated and the measured value is displayed
inverted in Ec.00/Ec.10.
On changing the encoder interface the error „
E.HybC“ is indicated. The change is confirmed by
writing on pa-
rameter Ec.00 or Ec.10 and the default values for the new interface are loaded. From version 4.2 the message
is acknowledged with error reset (terminal ST or RST).