Ikegami OCP-300, Operation Manual

Page: 98 / 274

5-6 5. Operation of the Control Knob
5.3 Reconnection Process
The control knob position is sent to the camera as the absolute data. Therefore, with the
conventional OCP, when the command between the camera and the control panel is
reconnected after turning on/off the camera power supply or the panel enable, jumping
of the camera data occurs if the control knob position is different between before and
after the reconnection.
With OCP-300, the operation amount of the control knob is sent as the relative data.
Therefore, jumping of the camera data does not occur even when the control knob
positions are different between before and after the reconnection.
㻡㻜
㻡㻜 㻡㻜 㻟㻣
䝬䝙䝳䜰䝹
䝣䜯䜲䝹
㻠㻣
㻢㻜
෌᥋⥆
㻠㻣㻙㻢㻜㻩㻙㻝㻟
㻻㻯㻼䠉䠎䠌䠌
䝁䞁䝖䝻䞊䝹
䛴䜎䜏
OCP-300
Conventional OCP
Volume file
Control knob
Reconnection
Manual file
Control knob
Reconnection
Manual file
Volume file
Conventional OCP
Reconnection