Ikegami OCP-300, Operation Manual

Page: 151 / 274

11. Setting the Panel Assignment and Program Number 11-9
11.5 Display Mode of Program Number
If the control panel is connected to the camera head without program number function
(the number is stored even when the display function is not available), the program
number will be retained because it cannot be obtained from the camera head. For this
reason, some inconvenience may occur.
The number can be stored for the connection setting (Assign setting) of BS/CCU only
when the network is connected. The operation described in the previous section "11.2
Program Number for Changing the Panel Assignment" is for CAM mode while the
operation that stores the number with the Assign setting is for SELF mode. You can
switch between CAM mode and SELF mode in the panel configuration (panel setting).
Reference
: Please refer to "21.1.3 Setting Items" for operation procedures.
1. Changing the connected BS/CCU
Ex.): ARC ID 1 ń 3
IP ADDRESS 192.168.1.100
ń 192.168.1.101
2. Changing
the
connection
3. Acquisition of program number
Program number
No function