![background image](http://html2.mh-extra.com/html/icom/id-31a-plus/id-31a-plus_advanced-manual_4733647070.webp)
5
GPS OPERATION
5-3
NOTE:
Before using the GPS function, read “IMPORTANT NOTES” about the GPS receiver in BASIC MANUAL
page vi.
The transceiver has a built-in internal GPS receiver.
The GPS receiver’s position data can be received in
any mode. Also, a NMEA format compatible external
GPS receiver can be connected to the transceiver
through the [DATA] jack.
To receive signals from an external GPS receiver,
connect it to the transceiver as shown below.
NOTE:
Transmit or receive position data can be
transmitted in only the DV mode.
Connection
GPS
Receiver
(Third party)
To the
RS-232C port
cable
To the
[DATA] jack
2.5 mm
(0.1 in) (d)
less than 6.0 mm
(0.2 in) (d)
TxD
RxD
GND
2
3
5
6
9
1
• Connect Pin
2
to RxD (Ring).
• Connect Pin
3
to TxD (Tip).
• Connect Pin
5
to GND (Sleeve).
D
Confi rming the GPS signal receiving
Confi rm the GPS receiver is receiving satellite signals.
The GPS icon blinks when searching for satellites.
→
→
→
The GPS icon stops blinking when the minimum
number of satellites needed are found.
Information
L
• It may take only a few seconds to receive, or it may
take a few minutes, depending on your operating
environment. If you have diffi culties receiving, we
recommend that you try a different position.
• When
GPS Select
is set to “Manual,” the icon is not
displayed. When using a third party GPS receiver,
set to “External GPS.”
(MENU > GPS > GPS Set >
GPS Select
)
•
Set
GPS Indicator
to “ON” to display the GPS icon.
(MENU > GPS > GPS Set >
GPS Indicator
)
Before starting GPS operation
TIP:
To prolong the battery life in the GPS mode
To prolong the battery life while operating in the
GPS mode, manually update your position with the
received GPS data.
1� Set
GPS Select
to “Internal GPS,” and receive
your position from the internal GPS receiver.
(MENU > GPS > GPS Set >
GPS Select
)
2�
Open the MANUAL POSITION screen, and
then push [QUICK] .
(MENU > GPS > GPS Set>
Manual Position
)
3�
Select “Capture From GPS.”
• Your current position is now memorized and
displayed on the MANUAL POSITION screen.
4� Set
GPS Select
to “Manual.”
(MENU > GPS > GPS Set >
GPS Select
)
NOTE:
Continuously using the Internal GPS
mode causes the transceiver’s battery to quickly
be exhausted. Turn ON the Power Save mode if
needed. See page 11-9 for details.
( MENU > GPS > GPS Set >
Power Save (Internal
GPS)
)