IBM FlashSystem 900, Service Manual

Page: 251 / 546

3746-900 Procedures
Engineering Data Transfer
Overview
The engineering data can be transferred in three main ways:
¹
On diskettes
¹
DCAF (Distributed Console Access Facility) via LAN, SDLC
¹
Using Java file manager.
The transfer can be done from:
¹
The local service processor using diskettes (when files are not too big)
¹
The remote service processor using DCAF or console for Java.
Preparing Engineering Data on the Local Service Processor
1. If not already logged, enter the "Service Processor maintenance password" (default is IBM3745), or
ask the customer if a specific password has been defined.
2. Double click on the "Service Processor" icon.
3. Click on "Operation Management".
4. Double click on "Manage Engineering Data". The following window is displayed:
Figure 1-16. Manage Engineering Data Window
5. Enter the PMH number, the branch office and the country codes.
6. Select the "processor" with the radio button. If you do not want zip some of these files, select them
and click on "Remove".
7. Repeat the two preceding Steps for each processor.
8. When you have terminated your selection, click on "Create Zip Files...", then wait until the message
"zip files successfully created" is displayed.
9. Click on "OK".
Note: The Zip files created are on the disk H: of the service processor.
Chapter 1. START
1-157