IBM eServer xSeries 345 Type 8670, Maintenance Manual

Page: 30 / 176

Using the LSI Logic Configuration Utility program
You can use the built-in, menu-driven LSI Logic Configuration program to:
v Perform a low-level format on a hard disk drive
v Set the SCSI device scan order
v Set the SCSI ID for a controller
Notes:
1. The integrated SCSI controller with RAID capabilities in your server supports
RAID level 1 operation.
2. If your server has a ServeRAID-5i controller installed, you can use ServeRAID
Manager to configure the integrated SCSI controller with RAID capabilities for
additional RAID levels. If a ServeRAID-5i controller is installed and later
removed, you must re-enable the on-board SCSI controller in using the
Configuration/Setup Utility program (see “Starting the Configuration/Setup Utility
program” on page 11).
Complete the following steps to start the LSI Logic Configuration Utility program:
1. Turn on the server and watch the monitor screen.
2. When the
Press CTRL C to start LSI Logic Configuration Utility
prompt
appears, press Ctrl+C.
Note: If an administrator password has been set, a prompt appears asking you
to type the password to start the LSI Logic Configuration Utility program.
Figure 7. Hints and tips feature
20
xSeries 345 Type 8670: Hardware Maintenance Manual and Troubleshooting Guide