IBM eServer xSeries 345 Type 8670, Maintenance Manual

Page: 100 / 176

Note: See “System” on page 116 to determine which components should be replaced by a field service technician.
Error code/symptom FRU/action
035-253-S99
(RAID adapter initialization failure)
1. ServeRAID adapter in slot s is not configured properly. Obtain
the basic and extended configuration status and see the ServeRAID
Hardware Maintenance Manual for more information.
2. Cable.
3. SCSI backplane.
4. Adapter.
075-XXX-000
(Failed power supply test)
v Power supply
089-XXX-001
(Failed microprocessor test)
1. VRM 1 for microprocessor 1
2. Microprocessor 1
089-XXX-002
(Failed optional microprocessor test)
1. VRM 2 for optional microprocessor 2
2. Optional microprocessor 2
166-198-000 System Management:
Aborted
(Unable to communicate with ASM. It may
be busy. Run the test again.)
1. Run the diagnostic test again.
2. Correct other error conditions and retry. These include other failed
system management tests and items logged in the System Error
Log of the optional Remote Supervisor Adapter.
3. Disconnect all server and option power cords from the server, wait
30 seconds, reconnect, and retry.
4. Remote Supervisor Adapter, if installed.
5. System board.
166-201-001 System Management: Failed
(I2C bus error(s) See SERVPROC and
DIAGS entries in event log.)
1. If installed, reseat the I2C cable between the Remote
Supervisor Adapter (in PCI slot 5/J5 on the PCI riser card) and
system management connector on the PCI riser card.
2. Reseat memory DIMMs.
3. Memory DIMMs.
4. System board.
166-201-002 System Management: Failed
(I2C bus error(s) See SERVPROC and
DIAGS entries in event log.)
1. Reseat I2C cable between the operator information panel and
the system board (J22).
2. Diagnostics panel.
3. System board.
166-201-003 System Management: Failed
(I2C bus error(s) See SERVPROC and
DIAGS entries in event log.)
1. Reseat cables between the system board and the power supply
or power cage assembly.
2. Power cage assembly.
3. System board.
166-201-004 System Management: Failed
(I2C bus error(s) See SERVPROC and
DIAGS entries in event log.)
1. DASD backplane
2. System board
166-201-005 System Management: Failed
(I2C bus error(s) See SERVPROC and
DIAGS entries in event log.)
1. Reseat Memory DIMMs.
2. Reseat microprocessors.
3. Memory DIMMs.
4. Microprocessors.
5. System board.
90
xSeries 345 Type 8670: Hardware Maintenance Manual and Troubleshooting Guide