![background image](http://html1.mh-extra.com/html/hyundai/hx130-lcr/hx130-lcr_manual_2196326097.webp)
2-53
2. PRINCIPLE OF DRIVING
※
Descriptions are based on the type 1 of the swing motor.
1) GENERATING THE TURNING FORCE
The high hydraulic supplied from a hydraulic pump flows into a cylinder block (8) through valve casing
(22) of motor and valve plate (20).
The high hydraulic is built as flowing on one side of Y-Y line connected by the upper and lower sides of
piston (12).
The high hydraulic can generate the force, F1=P
×
A (P : supplied pressure, A : fluid pressure area),
like following pictures, working on a piston.
This force, F1, is divided as N1 thrust partial pressure and W1 radial partial pressure, in case of the
plate of a tilt angle,
α
.
W1 generates torque, T=W1+R1, for Y-Y line connected by the upper and lower sides of the piston as
following pictures.
The sum of torque (
Σ
W1
×
R1), generated from each piston (4~5 pieces) on the side of a high
hydraulic, generates the turning force.
This torque transfers the turning force to a cylinder (8) through a piston; because a cylinder is
combined with a turning axis and spline, a turning axis rotates and a turning force is sent.
Low
pressure
High
pressure
Pistion
F1
f1
N1
W1
Y
Y
R1
P
A
O
W1
Cylinder
140WF8TM05
Summary of Contents for HX130 LCR
Page 11: ...1 1 SECTION 1 GENERAL Group 1 Safety Hints 1 1 Group 2 Specifications 1 10 ...
Page 174: ...4 5 MEMORANDUM HYUNDAI HEAVY INDUSTRIES CO LTD CONSTRUCTION EQUIPMENT DIV ...
Page 536: ...8 108 125LCR8TM30 Turn casing 1 upside down and remove oil seal 3 using jig 29 ...
Page 566: ...8 138 Remove lock nut 22 and then boot 23 14 36078RL14 2507ARL10 ...