5-44
J1939 Code
Description
Refer to Procedure
1110-31
Engine Protection System has Shutdown Engine
The engine protection system has
shutdown the engine. Troubleshoot all other
diagnostic codes in order to clear this code.
1127-16
Engine Turbocharger 1 Boost Pressure : High -
moderate severity (2)
Intake Manifold Air Pressure Is High
1127-18
Engine Turbocharger 1 Boost Pressure : Low -
moderate severity (2)
Intake Manifold Air Pressure Is Low
1188-5
Engine Turbocharger Wastegate Actuator 1 Position
: Current Below Normal
Solenoid Valve - Test
1188-6
Engine Turbocharger Wastegate Actuator 1 Position
: Current Above Normal
Solenoid Valve - Test
1209-3
Engine Exhaust Gas Pressure : Voltage Above
Normal
Sensor Signal (Analog, Active) - Test
(Exhaust Gas Pres- sure Sensor)
1209-4
Engine Exhaust Gas Pressure : Voltage Below
Normal
Sensor Signal (Analog, Active) - Test
(Exhaust Gas Pres- sure Sensor)
1221-2
Continuously Monitored Systems Support/Status ;
Erratic, Intermittent, or Incorrect
ECM Memory - Test
1221-14
Continuously Monitored Systems Support/Status ;
Special Instruction
Another diagnostic code has requested
engine speed limitation.
The warning lamp will flash. The engine
speed is limited to 1200 rpm.
Troubleshoot all other diagnostic codes. If
this code is the only active diagnostic code,
replace the ECM. Refer to Troubleshooting,
“ECM - Replace”
1239-0
Engine Fuel Leakage 1 : High - most severe (3)
Fuel Rail Pressure Problem
1485-7
ECM Main Relay : Not Responding Properly
Relay - Test (ECM Main Relay)
1485-14
ECM Main relay : Special Instruction
Relay - Test (ECM Main Relay)
2791-5
Engine Exhaust Gas Recirculation (EGR) Valve
Control : Current Below Normal
Motorized Valve - Test
2791-6
Engine Exhaust Gas Recirculation (EGR) Valve
Control : Current Above Normal
Motorized Valve - Test
2791-7
Engine Exhaust Gas Recirculation (EGR) Valve
Control : Not Responding Properly
Motorized Valve - Test
2797-6
Engine Injector Group 1 : Current Above Normal
Injector Solenoid - Test
2797-7
Engine Injector Group 1 : Not Responding Properly Injector Solenoid - Test
2798-6
Engine Injector Group 2 : Current Above Normal
Injector Solenoid - Test
2840-12
ECU Instance : Failure
ECM Memory - Test
2840-14
ECU Instance : Special Instruction
Relay - Test (ECM Main Relay)
※
Some fault codes are not applied to this machine.
Summary of Contents for HX130 LCR
Page 11: ...1 1 SECTION 1 GENERAL Group 1 Safety Hints 1 1 Group 2 Specifications 1 10 ...
Page 174: ...4 5 MEMORANDUM HYUNDAI HEAVY INDUSTRIES CO LTD CONSTRUCTION EQUIPMENT DIV ...
Page 536: ...8 108 125LCR8TM30 Turn casing 1 upside down and remove oil seal 3 using jig 29 ...
Page 566: ...8 138 Remove lock nut 22 and then boot 23 14 36078RL14 2507ARL10 ...