![background image](http://html1.mh-extra.com/html/hyundai/hx130-lcr/hx130-lcr_manual_2196326111.webp)
2-67
Operation
Two pieces of overload valves are located at cross-over position in the counterbalance circuit of
brake valve and have the following functions :
When hydraulic motor starts, keep the driving pressure below predetermined value and while
accelerating, bypasses surplus oil to return line.
When stopping the motor, keep the brake pressure, that develops on the outlet side of motor,
under the predetermined value to stop the inertial force.
To accelerate sharply while starting, and to mitigate the braking shock while stopping. For these
purposes, the developed pressure is kept comparatively low for a short period, then keep the line
pressure as normal value. While the pressure is low, meshing of reduction gears, crawler and
sprocket etc. can be smoothly done and the shock are absorbed.
When starting, "A" port pressure of overload valve increases, this pressure is applied to the
effective diameter of poppet (38-8) which seats on the poppet seat (38-9) and, at the same time,
is delivered, via small hole, to the spring seat (38-3) located inside the sleeve (38-4) and the seat
bore pressure increases up to "A" port pressure. The poppet (38-8) opposes to spring (38-2) by
the force of the pressure exerted on the area difference between poppet seat's effective diameter
and spring seat bore and keep the predetermined pressure.
When hydraulically braking, the piston (38-5) is at the left position by the driving pressure, and
when "A" port pressure increases, the pressure is applied also to the piston (38-5) through the
small hole in the poppet (38-8), sleeve (38-4) and piston (38-5) moves rightward until it touches
the stopper in rear cover. In this while, the poppet (38-8) maintains "A" port pressure at
comparatively low against the spring (38-2) force and exhaust oil to "B" port side. After the piston
reached to the plug, the valve acts the same as at starting.
Spring(38-2)
Spring seat(38-3)
Piston(38-5)
Poppet seat(38-9)
Sleeve(38-4)
Small hole
Port A
Port B
125LCR2TM27
①
②
③
(2)
Summary of Contents for HX130 LCR
Page 11: ...1 1 SECTION 1 GENERAL Group 1 Safety Hints 1 1 Group 2 Specifications 1 10 ...
Page 174: ...4 5 MEMORANDUM HYUNDAI HEAVY INDUSTRIES CO LTD CONSTRUCTION EQUIPMENT DIV ...
Page 536: ...8 108 125LCR8TM30 Turn casing 1 upside down and remove oil seal 3 using jig 29 ...
Page 566: ...8 138 Remove lock nut 22 and then boot 23 14 36078RL14 2507ARL10 ...