5-65
130ZF3CD219
130ZF3CD220
130ZF3CD221
This warning lamp lights ON or BLINK when the regeneration is
needed.
When this lamp lights ON or BLINK, press the DPF switch to
manual regeneration position (I) at least 2 seconds to initiate the
manual DPF regeneration.
When the manual regeneration is started, the DPF lamp will be
turned off and HEST lamp will be ON.
Consequences of delaying regeneration
- Poor performance caused by increasing exhaust gas pressure.
- Higher fuel consumption
- Shorter filter lifetime
Refer to the operator's manual page 3-39 for the DPF switch
operation.
This warning lamp lights ON or BLINK when pressing the DPF
switch at inhibit position (II) at least 2 seconds.
When this lamp lights ON or BLINK, the automatic or manual
regeneration does not occur.
To clear the Inhibit lamp, pressing the DPF switch once again at
inhibit position (II) at least 2 seconds.
This warning lamp indicate high temperature of the exhaust system
due to DPF regeneration.
The lamp will also illuminate during the manual DPF regeneration.
When this lamp is illuminated, be sure the exhaust pipe outlet is not
directed at any surface or material that can be melted, burn, or
explode.
The exhaust gas temperature could reach 650 °C [1200 °F], which
is hot enough to ignite or melt common materials, and to cause
burns.
The lamp does not signify the need for any kind of equipment or
engine service; It just alerts the operator to high exhaust
temperatures. It is common for the lamp to illuminate on and off
during normal equipment operation as the engine completes DPF
regeneration.
①
②
③
①
②
③
①
②
③
※
DPF (Diesel Particulate Filter) warning lamp
DPF regeneration inhibit warning lamp
HEST (High Exhaust System Temperature) warning lamp
(11)
(12)
(13)
※
※
Summary of Contents for HX130 LCR
Page 11: ...1 1 SECTION 1 GENERAL Group 1 Safety Hints 1 1 Group 2 Specifications 1 10 ...
Page 174: ...4 5 MEMORANDUM HYUNDAI HEAVY INDUSTRIES CO LTD CONSTRUCTION EQUIPMENT DIV ...
Page 536: ...8 108 125LCR8TM30 Turn casing 1 upside down and remove oil seal 3 using jig 29 ...
Page 566: ...8 138 Remove lock nut 22 and then boot 23 14 36078RL14 2507ARL10 ...