8-115
125LCR8TM53
125LCR8TM55
125LCR8TM54
125LCR8TM56
After spreading grease sufficiently to the bottom
side of valve plate (24), assemble valve plate in
rear cover by matching its holes with pins.
Take care not to damage sliding surface.
Pay attention to the assembly direction.
Assemble O-ring (27) in rear cover.
Spread grease on O-ring.
Put rear cover upon casing, paying attention to
the location of pin and hole. And tighten bolt
(47), (48) and (49).
Tightening torque : 17.5±1.8 kgf · m
(127±13.0 lbf · ft)
Make sure valve plate stays in place.
Check bolt position.
Assemble main spool assembly (31), spring seat
(37) and spring (33) in rear cover.
(23)
※
※
(24)
※
(25)
※
※
※
(26)
Summary of Contents for HX130 LCR
Page 11: ...1 1 SECTION 1 GENERAL Group 1 Safety Hints 1 1 Group 2 Specifications 1 10 ...
Page 174: ...4 5 MEMORANDUM HYUNDAI HEAVY INDUSTRIES CO LTD CONSTRUCTION EQUIPMENT DIV ...
Page 536: ...8 108 125LCR8TM30 Turn casing 1 upside down and remove oil seal 3 using jig 29 ...
Page 566: ...8 138 Remove lock nut 22 and then boot 23 14 36078RL14 2507ARL10 ...