HP 34401A, User Manual

Page: 175 / 236

-221
Settings conflict
This error can be generated in one of the following situations:
•
You sent a
CONFigure
or
MEASure
command with autorange enabled
and with a fixed resolution. Example:
CONF:VOLT:DC DEF,0.1
•
You turned math on (
CALC:STAT ON
) and then changed to a math
operation that was not valid with the present measurement function.
For example, dB measurements are not allowed with 2-wire ohms.
The math state is turned off as a result of this condition.
-222 Data out of range
A numeric parameter value is outside the valid range for the command.
Example:
TRIG:COUN -3
-223 Too much data
A character string was received but could not be executed because the
string length was more than 12 characters. This error can be generated
by the
CALibration:STRing
and
DISPlay:TEXT
commands.
-224 Illegal parameter value
A discrete parameter was received which was not a valid choice for
the command. You may have used an invalid parameter choice.
Example:
CALC:FUNC SCALE
(
SCALE
is not a valid choice).
-230
Data stale
A
FETCh?
command was received but internal reading memory was
empty. The reading retrieved may be invalid.
-330
Self-test failed
The multimeter’s complete self-test failed from the remote interface
(
*TST?
command). In addition to this error, more specific self-test errors
are also reported. See also “Self-Test Errors,” starting on page 179.
Chapter 5 Error Messages
Execution Errors
176