ENGINE MECHANICAL (J05E)
10–20
(2)
Mount the camshaft bearing by aligning with the cylinder head
concave and apply engine oil.
3.
MOUNTING THE CAMSHAFT
(1)
Place the camshaft assembly in a way that the 2 drill holes posi-
tioned at 180
(timing judging drill holes) out of the 3 holes of the
camshaft gear are kept level to the cylinder head upper surface.
! CAUTION
Set the clear plastic scale or edged scale against the upper sur-
face of the cylinder head and the side of the camshaft gear. Check
that the wrong mounting preventing drill hole is located above the
scale.
(2)
Place the camshaft bearing caps in a way that the marks face to
the engine front side and the engraved numbers are positioned in
the order of 1-5 from front to back.
Tightening Torque:
36 N·m {367 kgf·cm, 27 lbf·ft}
(3)
Check that the end play of the camshaft is within the standard
value.
4.
MOUNTING THE ROCKER ARM ASSEMBLY
(1)
Loosen the lock nut and wind up the adjust screw completely,
mounting the rocker arm assembly.
5.
MOUNTING THE INJECTOR HARNESS
Reference: FUEL SYSTEM (J05E), INJECTOR, REPLACE-
MENT, MOUNTING THE INJECTOR (Page 7-41)
6.
MOUNTING THE HEAD COVER
Reference: ENGINE MECHANICAL (J05E), HEAD COVER,
REPLACEMENT, MOUNTING THE HEAD COVER (Page 10-4)
CAMSHAFT
BEARING
DENT PART
SHTS021270900039
TIMING JUDGING
DRILL HOLE
WRONG INSTALLATION
PREVENTING DRILLHOLE
SCALE
SHTS021270900040
1
2
3
4
5
FRONT OF ENGINE
SHTS021270900041
