ENGINE MECHANICAL (J05E)
10–68
MOUNTING THE FLYWHEEL HOUSING
1.
MOUNTING THE FLYWHEEL HOUSING
(1)
Fasten the damping stud onto the flywheel housing.
Tightening Torque:
55 N·m {561 kgf·cm, 41 lbf·ft}
(2)
Use the scraper to remove dirt and fouling from the joint surfaces
of the flywheel housing and rear end plate.
(3)
Apply liquid gasket (ThreeBond TB1207D: Silver or equivalent or
ThreeBond TB1217G: Gray or equivalent) to the flywheel housing
as shown in the figure.
! CAUTION
•
Apply the liquid gasket seamlessly.
•
Apply the liquid gasket with 1.5-2.5 mm {0.0590-0.0984 in.}
width.
•
Mount the case within 20 minutes after applying the liquid
gasket.
(4)
Fasten 2-4 guide bolts and align the flywheel housing with the cyl-
inder block mounting position along the guide bolts.
(5)
Tighten the bolts and nuts with the specified tightening torques to
secure the flywheel housing.
Tightening Torque:
196 N·m {1,999 kgf·cm, 145 lbf·ft}
Part A: M16
28.5 N·m {291 kgf·cm, 21 lbf·ft}
Part B: M8
55 N·m {561 kgf·cm, 41 lbf·ft}
Part C: M10
55 N·m {561 kgf·cm, 41 lbf·ft}
Part D: M10
VIBRATION CONTROL
STUD
SHTS021270900144
LIQUID GASKET
LIQUID
GASKET
SHTS021270900145
HV ONLY
A
C
A
A
A
A
A
A
A
A
A
A
A
D
D
C
C
C
C
C
B
B
B
B
SHTS021270900146
